Plastic Float Valve RO Unit 6mm

I am designing the water change system and I require a Plastic Float Valve for use with RO unit.

RO Float Valve

PVC Plastic Float Valve

PVC plastic float valve ideal for low flow, automatic level control applications.
Fixed arm is tank mountable with integral bulkhead fitting. 0.093″ orifice with free flow outlet. Estimated flow rate of 1.5 GPM at 40 PSI, the sealing operation has been tested to 100 PSI+.
Valves come complete with jam nut, sealing washer, polyethylene float, and 18-8 stainless steel hardware.

This float valve can be used in conjunction with an auto shutoff valve to stop RO production when a reservoir is full.

It can also be used as an auto top-off device in an aquarium.

All parts are made from NSF approved materials. Replaceable seals are made of long-wearing, chemical resistant Santoprene® rubber.

But I also found:-

Auto Shutoff Kit with Float Valve


RO Auto Float Valve

RO Auto Float Valve

This kit allows RO units to shut-off or stop producing waste water after the float valve closes.

If using this kit with a booster pump you will need a High Pressure Switch to stop the booster pump when your collection vessel is full.

Parts include:

2 Metres Tubing
Auto Shut Off Pressure Valve
Float Valve
RO Outlet Check valve
Installation Instructions

This entry was posted on Monday, May 31st, 2010 at 6:44 pm and is filed under Bespoke Aquarium. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.